Anodized Aluminium extrusion for infill on 40x40 extrusion, to give a tidy flush finish.
Available in 3m & 1.5m lengths.
Suitable for concealing & securing cables, or just to get a clean tidy finish.
This extrusion has been designed to be a gentle clip fit, and can be removed again without damage. For a tighter fit, the legs of the extrusion can be twisted out slightly with a screwdriver every few hundred mm.
Jig marks: This is manufactured as an industrial product. Some anodised pieces will have jig marks from the anodising process up to 50 mm from each end, and these are more visible on black. Leaving these ends on rather than cutting them off as scrap minimises waste and keeps the cost down. The marks can usually be orientated to a non-visible position in your build. If your project needs an absolutely perfect surface, allow an extra 50 mm at each end when ordering and trim to length as required. We are unable to cut around jig marks at the factory.